How can the intensity not be high when reps are high?
You pretty much answer your own question in your next post but I thought I'd add for clarification. Intensity and volume are inversely related in weight lifting (and with most other activities too). That is, as one goes up the other MUST go down. I think the misunderstanding here is based again on terminology. Intensity as I'm using it is not a term to indicate how much you sweat or puke or how hard one works. Intensity as I use it refers to the % of maximal effort at which the work is done without respect to duration. I generally make the cutoff for high intensity work to be anything that is done above 85% of maximal effort. An example would be squatting. Loading a bar with 90% of one's squat 1RM would be very intense. At this high intensity, an athlete could only be expected to do about 3 reps (low volume). At lower intensities (say 60%) one could do many more reps (~volume). Load however is not the only factor at play when determining intensity. Speed of movement also has an effect on intensity. The faster you attempt to move, the greater the intensity. Keeping this in mind, one could have a very intense squat workout with only 70% of one's 1RM on the bar if the emphasis was on speed of movement. Having said that, this high intensity would only be able to be maintained for a very low volume, after which the speed of movement would drastically drop off due to fatigue.
Fatigue should not set in until around 25th reps if at all.
Fatigue will begin almost immediately, when it manifests itself is another story. I am certain if you were to do high speed video analysis that you would see that speed of movement would drop off significantly around reps 3-10 depending on the load you use.
ELITETRACK Founder